"Driver Inattention"
#43
snapped a couple pictures, yes I need to get my front end put back together, been working the last few weeks stright though so haven't had much time but bummper cover is about done.......
#47
well I guess I should make a update, took a trip to MN pounded 3200 miles on her. coil overs seem to be holding up nicely, still need to get started on the rest of the body and get new intake pieced together, higher powered coil put in..... kinda at a stalemate with money and time at the moment, but yes work will continue on her.....
#48
Hey man, do you have any more photos of the rear coilovers or a parts list? I have a general idea what I would do on my car int he rear since I had to do something almost the same on the front of my Supra.
I want to do a decent suspension on my Maxima soon.
I want to do a decent suspension on my Maxima soon.
#49
for the rods and heim joints...... I just searched online, then ordered spacers from https://technotoytuning.com/ I just got the ones they already make and cut down the ones that needed it and used washers on the ones that were to short, I don't remember which ones they were, but they make them that adapt SAE heim joints to Metric bolts....
Last edited by vernk; 05-28-2014 at 05:26 PM.
#51
but yea if you run across one cheep let me know I can always throw it on her stack of parts I have waiting for her...
#53
Nice job! That coilover setup would be similar to what a 3rd Gen needs since the 2nd and 3rd Gens are so close in design!!! Those 2000 Altima SE wheels look nice on that 2nd Gen (16" ers)...
Thread
Thread Starter
Forum
Replies
Last Post
Dennis Twohy
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
0
10-01-2015 06:01 PM