Non-contact front license plate?
#1
Newbie - Just Registered
Thread Starter
iTrader: (11)
Join Date: Apr 2013
Location: Long Island, NY
Posts: 1,167
Non-contact front license plate?
Does anyone know of a custom front plate bracket that doesnt involve any drilling into the bumper cover or magnets?
I did some searching and found a website that sells a bracket like this for the 7th gens, but i cant find anything that specifically fits 4th gens (97-99 of that matters).
Worst case scenario i guess i can go the magnet route but if anyone knows a solution that taps into the frame/bumper/rad support without touching the front bumper cover - certainly let me know!
I did some searching and found a website that sells a bracket like this for the 7th gens, but i cant find anything that specifically fits 4th gens (97-99 of that matters).
Worst case scenario i guess i can go the magnet route but if anyone knows a solution that taps into the frame/bumper/rad support without touching the front bumper cover - certainly let me know!
#3
I used a black door hinge from Home Depot. Cheap, and only requires one bolt. Drill underneath the middle of the bumper where the mouth is. You will also have to drill a small hole in the top center of the plate.
#8
Newbie - Just Registered
Thread Starter
iTrader: (11)
Join Date: Apr 2013
Location: Long Island, NY
Posts: 1,167
Awesome thanks! How much of a drop does your car have if any? The only issue i could see arising with that setup is the plate getting annhilated by speed bumps and such lol. But i think ill give it a try anyways.
#11
I don't have any tickets yet! Car has no drop at all. My plate has been bent on the bottom portion of it. You can see it on the corner. If I were to park in front of a curb, my car's height would just make it over but the plate would scrape over it haha.
#13
#14
Thread
Thread Starter
Forum
Replies
Last Post