bds1304

iTrader: (1)

hey im trying to finish up this ssim, was wondering if anyone on here has any good advice for cutting out the drivers side portion. i cant get none of my tools in there. any help would be greatly appreciated

maxima dude

all i used was a saw zal... used a metal blade about a foot long and went to town... stuck it in threw the block off plate hole and cut both sides of the shelve... then took a normal 6 inch blade and cut from inside the elbow hole at diffferent angles...takes time lol im fully bolted and had done this and hated the power...( was stupid to have cuz all you felt was from 5k to redline which is useless without the technosqaure ecu with the extended rev.)

jowo9

iTrader: (1)

Yeah really. SSIM FTL during daily driving. I even removed my block plate because most of my driving is below 4K rpm and stock wins there for power/torque.

bds1304

iTrader: (1)

yeah i know for power wise it sucks, but im going a different route now......looks like im goin to make another custom intake manifold again