Is a tap necessary for aluminum
#1
Is a tap necessary for aluminum
I am installing the (in)famous Mitzone aluminum valve covers. I removed the improper sheet metal screws and intend to buy the correct M4 x 07 machine screws. Is retapping the threads necessary or because it's aluminum, will the new screws themselves correct the thread damage from the improper sheet metal screws?
#3
#4
I WAS going to get aluminum valve covers. Since the screws that hold the ignition coil seal plate are questionable, I was going to modify it. After careful consideration, I decided to replace the warped plastic valve covers with OEM.
Thread
Thread Starter
Forum
Replies
Last Post
RaptonX
3rd Generation Maxima (1989-1994)
4
02-02-2014 05:24 PM