OBD Drive cycle help
#1
OBD Drive cycle help
As part of an enhanced emissions test for Inspection & Maintenance (I/M), some States may require the System Readiness Test (SRT) status be checked. - The SRT is used to indicate whether the engine control module (ECM) has completed self diagnosis of major emissions systems and components. -
I replaced my EVAP almost 500 miles ago, reset the codes with a code reader but the IM system shows the CAT as still not ready therefore I cannot pass a NY inspection.
Any suggestions?
I replaced my EVAP almost 500 miles ago, reset the codes with a code reader but the IM system shows the CAT as still not ready therefore I cannot pass a NY inspection.
Any suggestions?
#4
hes talking about the srt, not the actual emissions test.
drive the car some more.. get on the freeway and drive. turn the car off and on several times. also get up to hwy speeds, then let off the gas, and back to hwy speeds. that should get the monitors ready.
Last edited by 99greddymax; 11-16-2010 at 02:16 PM.
#5
As part of an enhanced emissions test for Inspection & Maintenance (I/M), some States may require the System Readiness Test (SRT) status be checked. - The SRT is used to indicate whether the engine control module (ECM) has completed self diagnosis of major emissions systems and components. -
I replaced my EVAP almost 500 miles ago, reset the codes with a code reader but the IM system shows the CAT as still not ready therefore I cannot pass a NY inspection.
Any suggestions?
I replaced my EVAP almost 500 miles ago, reset the codes with a code reader but the IM system shows the CAT as still not ready therefore I cannot pass a NY inspection.
Any suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
hez8813
5th Generation Maxima (2000-2003)
11
03-12-2020 12:06 AM
Maxima30
5th Generation Maxima (2000-2003)
2
09-07-2015 06:13 PM