grey99max

iTrader: (12)

I've purchased the Greddy cables for my next project, but how would I tell when a unit was manufactured? I'm guessing that the internal circuit board has some label to identify it, but what is the most current production code?

I've asked a couple of vendors - and Greddy - that question, but still no answers in 24 hours. I see a lot of Ultimates for sale by a bunch of vendors, but there must be lots of older units still out there.

Anyone know what to look for?

Unklejoe

iTrader: (6)

I think revision D is the newest. It should say "D" somewhere on the circuit board.

grey99max

iTrader: (12)

Photos of this part of the mother board would be good... Also, I see references to different levels of firmware - does anyone know what the most recent level is today?

Unklejoe

iTrader: (6)

The letter is located on the bottom right corner of the board. This is a version B board.

- Photo taken from DandyMax's guide.

The most current software is version 2.20.

A link to the software can be found in my thread:

http://forums.maxima.org/all-motor/6...en-review.html

tedo007

iTrader: (6)

make sure you don't pay more than 300 for yours

grey99max

iTrader: (12)

Outstanding information! Thanks... And I've already studied your thread...

.

grey99max

iTrader: (12)

Hummm... I haven't found any new Ultimates for under $500 yet. Where would I seek such a wonderous bargain?

tedo007

iTrader: (6)

I looked for it on craiglist and on 350z forums. I bought two in past 2 years. First one off 350z and second one on craiglist and both of them I paid 300 each now that is with full harness.

Unklejoe

iTrader: (6)

I had to buy two also. First one for $375 with harness, second one for $315 with harness also.

I bought my second one off of the Mazda Miata forums lol

If you find one without a harness, I will sell you my spare harness for $25 shipped.

tedo007

iTrader: (6)

That harness is so cheap joe. Sell it on ebay you can get pretty penny out of those.