aw11power

so im looking for advice on a clutch upgrade. ive found that 85-99 manuals all have interchangable clutch/pressure plate assemblies. what have you guys had good luck with?

akurtzer57

iTrader: (4)

I ran southbend with good results and now on a spec but haven't drove with the spec yet. I actually used a z31 clutch this time around just due to it laying on the shelf in the box.

aw11power

is the Z31 clutch a direct fit? 240mm or 250mm? my friend at orielly could warranty my current lifetime clutch and ai could upgrade to a Z31 clutch for almost nothing out of pocket. i know the turbo clutches are good for 340lbs of torque, i dont know about the NA clutches. any help would be greatly appreciated. even tho my car is an 88, im using a 91 flywheel, clutch and pressure plate. so whatever fit yours would also fit mine.

Chris Gregg

iTrader: (59)

I had a Spec stage III IN MY '89 Turbo. Absolutely perfect, no issues or complaints.

Nealoc187

iTrader: (23)

how high of torque are we talking about here?

aw11power

ill need something thats good for over 350lbs of torque.

akurtzer57

iTrader: (4)

Was pretty much direct swap. I believe I had to just slightly enlarge the alignment pin. Wouldn't quite slip on my flywheel with paint etc. Did use the maxima throw out bearing.