Idler pulley part
#2
your best bet is go to Napa and find one that is about the right size and use some washer to get the spacing right, or if you still have your original see if you can still read the bearing number and just replace the bearings, I don't remember which one I used, but you just need one with the right diameter and bolt size and a few washers
#3
although you can still get factory ones
https://www.nissanpartsdeal.com/part...ED)&PNC=11925M
https://www.nissanpartsdeal.com/part...FED)&PNC=11925
https://www.nissanpartsdeal.com/part...ED)&PNC=11925M
https://www.nissanpartsdeal.com/part...FED)&PNC=11925
#4
Best and cheapest thing to do is buy the Bearing and replace it...$7-$10 (Grainger) or any online bearing store.... also remember this VG30E is in Mercury Villagers, 200SX, Maximas (2nd/3rd Gens), Nissan Xterra, Frontiers, Hardbody, and Pathfinders...plenty of VG30 engines with tensioners on them!
Thread
Thread Starter
Forum
Replies
Last Post
neo_densetsu
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
3
01-02-2004 10:31 PM
JMunaretto
3rd Generation Maxima (1989-1994)
6
01-15-2003 06:48 AM
crsmax
3rd Generation Maxima (1989-1994)
16
10-10-2000 08:17 AM