Update: Another round begins
#1
Update: Another round begins
Yea, I know I've said, "this is it" at least twice before, but...Car goes into the body shop tomorrow to get the cleared-out grill repainted. I pretty much have the mesh insert made and ready to go. I may epoxy my Nismo badge that I have lying around onto the mesh in the lower right corner. Had to replace the euro turn signals already. The first ones melted. Got the tranny temp gage sender mounted on Sunday at Tilley's shop. Just had another window regulator break. This is the third! Good news is there's only one original one left to go. It's getting that replaced, an oil change and a chassis lube done before heading down to Nopi. Hope to finish the grill next weekend. The gages get installed next week and I'm putting fresh stickers on the rocker panels in front of the back wheels. Same stuff as I have, but they're very dirty and faded. Tranny cooler went in a couple weeks ago. Then it's to the detailers and off to Nopi! And once again....
This is it!
This is it!
#4
Re: Update: Another round begins
Originally posted by maxmizd27
Yea, I know I've said, "this is it" at least twice before, but...Car goes into the body shop tomorrow to get the cleared-out grill repainted. I pretty much have the mesh insert made and ready to go. I may epoxy my Nismo badge that I have lying around onto the mesh in the lower right corner. Had to replace the euro turn signals already. The first ones melted. Got the tranny temp gage sender mounted on Sunday at Tilley's shop. Just had another window regulator break. This is the third! Good news is there's only one original one left to go. It's getting that replaced, an oil change and a chassis lube done before heading down to Nopi. Hope to finish the grill next weekend. The gages get installed next week and I'm putting fresh stickers on the rocker panels in front of the back wheels. Same stuff as I have, but they're very dirty and faded. Tranny cooler went in a couple weeks ago. Then it's to the detailers and off to Nopi! And once again....
This is it!
Yea, I know I've said, "this is it" at least twice before, but...Car goes into the body shop tomorrow to get the cleared-out grill repainted. I pretty much have the mesh insert made and ready to go. I may epoxy my Nismo badge that I have lying around onto the mesh in the lower right corner. Had to replace the euro turn signals already. The first ones melted. Got the tranny temp gage sender mounted on Sunday at Tilley's shop. Just had another window regulator break. This is the third! Good news is there's only one original one left to go. It's getting that replaced, an oil change and a chassis lube done before heading down to Nopi. Hope to finish the grill next weekend. The gages get installed next week and I'm putting fresh stickers on the rocker panels in front of the back wheels. Same stuff as I have, but they're very dirty and faded. Tranny cooler went in a couple weeks ago. Then it's to the detailers and off to Nopi! And once again....
This is it!
#5
Re: Re: Update: Another round begins
Originally posted by Chris91SE
i told you to leave the grille alone i take it you axed your other ideas for new decals for the show?
i told you to leave the grille alone i take it you axed your other ideas for new decals for the show?
Thread
Thread Starter
Forum
Replies
Last Post
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
hez8813
5th Generation Maxima (2000-2003)
11
03-12-2020 12:06 AM