well, people who have it...remember that bend on it...where it rises up a little? anyway, it feels like when i put the hood down...it touches the hood. When the hood goes down with one click without force, it's fine. but i've realized that it takes a little more force to shut the hood compared to when there wasn't a FSTB in my car. does anyone know if it'll eventually dent the hood? i'm kinda of worried.

dont' know
 

i don't have this problem so i don't really know what your talking bout.. did you put it on correctly...i know it's really not that hard to install so you probably didn't. don't know what to tell you

saber

uh..u sure u have it right?
 

well..why don't u try to post a pic of it? because when i installed mine..i really didn't have any problem at all =) maybe u have it facing the wrong way?

My FSTB touches the hood liner too... >>>>
 

Just barely so I stick some foam tape to where it touches.

i have the courtesy fstb on my 97 se, the hood insulation do touch the brace, took alitrtle while before the insulation mold itself and the problem disappear.

well..
 

well i have the FSTB facing up...just like i've read in so many threads on this forum...and umm...that's all? maybe its my imagination...i keep thinking the hood is gonna get dented so whenever i drive i keep lookin at it haha.

Samething Here
 

wHEN i got my Courtesy FSTB, the brackets were red. Well, I painted then a couple layers of chrome paint to match the bar. Looks good. However, when I put the bar into my car, the driver's side bracket touches the hood liner and is rubbing away at my hard worked paint job on the FSTB. Basically, there is nothing you can do. I tried messing with the hood readjusting nuts the ever so slightly raises/lowers the height of the hood when it is closed, but that really didn't work. Try your manual or get the Haynes manual, it will tell you.

Erik
Southeast Maxima Group

I got the courtesy FSTB a few weeks ago. I don't notice it being hard to close, but when I pop the hood it pops up hard. Before it would barely come up (i think the hood shocks are going)

I mean when I first pull the hood release lever, it pop up hard. I have no worries though

Just installed the Courtesy FSTB and it came pre adjusted to the correct width but i noticed that the arch (which people are talking about how it touches the hood liner) was positioned outward, like towards the front of the car.

It touched the AC line a bit, but i tweaked the AC line so it doesnt touch at all now.

Should the arch be up towards the hood liner? Or does it not matter....if it does matter, how do i re-position the arch?

now im getting worried
 

Does it matter if the arch in my front strut bar isnt arches upwards toward the hood?

Re: Courtesy's FSTB
 

My FSTB is angled back toward firewall and doesn't touch at all. It does slightly alter the torque between the strut tops if you roll it forward but not so much you will notice it driving. Can't remember how it is threaded whether forward tightens orloosens the bar's brackets. I did have to cut out a notch on the drivers side to fit it in the holes though.

how would i go about
 

rolling the arch towards the hood?