High Beam Wierd Problem
Today I was driving around and wanted to flash someone b/c they almost caused an accident when I noticed that my High Beam didn't come on. I'm running the 9007 conversion harness with Sylvania Xtravisions. I followed all the instructions which included changing the ground and low beam wire on the old 9004 socket on the drivers side. I had this kit in for about 3 months and sparingly used my high beams. I checked the filaments and they look fine, no breaks. I noticed when I turned on the lights and than tried to switch to high beam I would hear a click from the relays. Could it be possible that my relay is blown? What else could cause my high beams to go suddenly. Thanks.
|
Wire connections, relays, anything really.
Not something very easily diagnosed over the internet. Check all of the connections especially where they ground and brights were swapped. |
I'm going to check all the wires thanks. I was just hoping someone may have had the same similar information. Thanks Spig
|
Like Spig said check all wiring connections and any where it may have rubbed through the coating. Also Ive run into problems where it looks like a good bulb and nothing blown but its a small small break in the filiment and wont light the highbeams.
|
I fixed it first thing this morning. One of my many tasks today. There was a wire they got loose from the relay to the positive terminal. I just spliced them back together. I can't believe I didn't see this last night. But than again it was dark with a small flashlight.
|
Originally Posted by speed racer
But than again it was dark with a small flashlight.
|
All times are GMT -7. The time now is 07:12 PM. |
© 2024 MH Sub I, LLC dba Internet Brands