IDing cupholder clip
 

98 i30
The cupholder rattles around in the console. It does this because the plastic "+" shaped locating tab on the front of the cupholder is broke, and because the metal clip on the back is missing (only two of three required metal clips installed on cupholder)

I can't repair the plastic "+" - but i'd sure love some help ordering the correct Nissan clip to slip into the receptacle on the rear of the cupholder

the first pic shows the clip I'd like to match (installed on the front, next to the broken "+" shaped tab). the second pic shows the location where the missing clip belongs. the clip is straight on one side and angled opposite

I guessed and ordered 96938-40U10 - however it is a symmetrical A-shaped clip and is not the correct part.

The wrong part I ordered is labled 96935AA in the diagram below:
https://www.infinitipartsdeal.com/pa...rs=96938-40U10

The individual components on the cupholder aren't exploded anywhere. It looks like I might be looking for what's lableled "96935A" - however its "Discontinued".


https://cimg2.ibsrv.net/gimg/maxima....b9b53182be.jpg
https://cimg5.ibsrv.net/gimg/maxima....c055b793dc.jpg
https://cimg8.ibsrv.net/gimg/maxima....ccc25c54bf.jpg

Did you ever find them? I have the same issue.

I bought one from a fellow org member.

put a WANTED ad in the Classified section on this board - lots of people will go yarding for $, or are parting a car