WA 5th/5.5th Gen Custom LED tails
#1
5th/5.5th Gen Custom LED tails
These tail lights are very much custom fabricated using the best LED available and collimator lens to focus the LEDs. It took me about 1 month to create the pair and it was a lot of hours BUT it was very special and better than any 5th gen tails out there IMO. Built thread is below.
https://maxima.org/forums/5th-genera...il-lights.html
I took it off the car a while back wanting to replace the crack lens with new ones. Well...life got very busy and it's been sitting collecting spider webs for months until someone here pmed me about it.
With new lens this would look very clean. You can see the driver side lens has big crack and removed. If you are not afraid to get your hand dirty, I would put the internals in the SE tails and THAT would look very sick.
For sale for $130 shipped, As-Is no warranty. You do need upgraded relay flasher to make the turn signal blinks correctly.The down side is that if your bulb is out, the other side will not blink fast ( like OEM ones). PENDING SALE.
Driver Side.
Passenger side
Plug and Play
https://maxima.org/forums/5th-genera...il-lights.html
I took it off the car a while back wanting to replace the crack lens with new ones. Well...life got very busy and it's been sitting collecting spider webs for months until someone here pmed me about it.
With new lens this would look very clean. You can see the driver side lens has big crack and removed. If you are not afraid to get your hand dirty, I would put the internals in the SE tails and THAT would look very sick.
For sale for $130 shipped, As-Is no warranty. You do need upgraded relay flasher to make the turn signal blinks correctly.The down side is that if your bulb is out, the other side will not blink fast ( like OEM ones). PENDING SALE.
Driver Side.
Passenger side
Plug and Play
Last edited by Genes1s; 11-06-2015 at 07:58 PM. Reason: Pending Sale
#3
SOLD
installed the lens on the driver side. Weld the cracks so moisture doesn't get it. Not too pretty but should be better than having cracked lens. Takes 24 hour for silicone ti cure. Plan to ship tomorrow.
installed the lens on the driver side. Weld the cracks so moisture doesn't get it. Not too pretty but should be better than having cracked lens. Takes 24 hour for silicone ti cure. Plan to ship tomorrow.
#6
So I checked the battery with a multimeter and the voltage seems normal but it's odd that this issue started pretty much right when I replaced the lights. Probably gonna go back to traditional bulbs at this point unfortunately.
Thread
Thread Starter
Forum
Replies
Last Post
Austin Gilson
General Maxima Discussion
1
05-01-2018 10:15 AM
20_Maxima_10
7th Generation Maxima (2009-2015)
37
11-08-2012 09:27 AM