GreekMaxima

I have a terrible noise from powerslot rotors... when stoping, noise all the time when i use the brake pedal!! this is normal guys? i had them for a week now...
let me know guys...

thanks!

2kGLE

what kind of noise?

VMosser323

iTrader: (1)

I just had my Powerslots installed last weekend. I have Hawk HPS on the fronts and Raybestos on the rears. I remember seeing the Powerslot instruction/guidance form that came with the rotors. It said that there will be a slight/mild grinding noise which is acceptable. When I got my car back form the install, I drove it about 100 miles breaking them in. They still make a slight noise, but nothing that sounds awkward.

2001SE

what kind of a slight noise, when braking hard or slow speeds?

i think i heard before that the Hawk pads are not good for consistent hard braking and if they are used a lot, they start to screech and make noises...but i am not sure

scopium

i got the same awful noise but i have Brembo slotted with PBR brakes

GreekMaxima

hmm... how can i explain? when i stop "sssss" when i let off the gas pedal "krrrr"

i was try to explain you...


I dont think this noise come from the pads...

2k2nyc

It's from the Hawk pads. I have Hawks on stock rotors, and mine do that also.

Quidproquo

My brakes make a slight noise when I tap them lightly, but no noise at all when I apply normal stopping pressure. I think the noise, in my case, is attributable to the slotted rotors.

I had an awful noise last week, but it turned out to be my hub bearings. Luckily that is under the 60k warranty and NNA fixed it for free.

GreekMaxima

but i heard HAWK is the best...

skalberti

I have drilled and slotted rotors and its a "hum" noise that you'll here under hard braking, especially going down hill. Which way are your slosts facing? If standing in fron of your wheel, are the slots swept back or are they pointing to the front of the car? They should be pointing to the front , that is where you'll get the best cooling and its also the way they were designed to work. The noise is common though. Hope this helps

2k2nyc

HAWK is good. The material used to make HAWK pads can produce noise, but it should reduce once the pads have heated up. Also, braking ability increases when they heat up.

VMosser323

iTrader: (1)

You mean you can choose which way the slots point?? I thought this was not possible considering the rotors are labeled L & R.

The noises I mentioned earlier are not anything I would consider loud, awkward, obnxious, or concerning. To me , it sounds like a "sssssss" and I can only hear it when I turn off the heater & radio and listen for it.

ghostrider17

iTrader: (6)

Definition of Irony:

The words Nissan of North American used in conjuction with the terms of WARRANTY and FIXED for FREE.

everyone repent -- the end of the world is near!

gr