00/01's with HIDs answer this please...
 

Trying to decide where to mount the ballasts and igniters for my recently installed Prolumen HID h4 hi/low 5000K kit...pics would be great!

no suggestions?

I screwed mine down where the batter was, but iff you take off your bumper it has a great spot on the re-enforcement there.

How is the output on the HI and LOW HIDs?

Just stick them to your fender

output is good...HID's and halogens burn at the same time with the highs on....really bright, great for country roads. need to aim the headlights down a little cuz there is a little glare

Any pictures of the light output perhaps?

++++++++++++1. plus make sure the ballast are sealed good. otherwise water will get in them.....

This is where I put my ballasts (I moved the horn behind the grill).

http://photobucket.com/albums/y5/vladb/Ball6.jpg

guys I am also about to install mine today or tomorrow. Do you think it is safe to attach the ignitors and ballasts using industrial strength velcro?

i used double sided 3M tape, and is has been fine

i'll get some pics of the light output early next week after i aim the headlights down a little bit

i used masking tape and duct tape......lol i only did it that way cause there was a big thunder storm on the way and i didnt use silicone or anything. Come to think of it i never redid it.