rearview mirrors
#1
rearview mirrors
My mirrors adjust automatically, however recently I noticed that they started adjusting lower than I really want them too. I keep correcting this issue, I even clicked on the "Set and then the 1" to keep it to my prefered vision, however I keep having the issue where they adjust lower than i want them to.
Anyone have any ideas? Maybe I'm just doing it wrong?
Anyone have any ideas? Maybe I'm just doing it wrong?
#2
Are you talking about the side mirrors adjusting when you switch into reverse? I did not know you could adjust how much they tilt down.
The only thing I can think of that might be your problem is that you have to be fully stopped to put positions in memory, make sure the 1 button's orange light comes on after you push the set button. If you still have problems I would just leave the mirror selector in the center so they don't tilt at all, at least until you figure out whats going on.
The only thing I can think of that might be your problem is that you have to be fully stopped to put positions in memory, make sure the 1 button's orange light comes on after you push the set button. If you still have problems I would just leave the mirror selector in the center so they don't tilt at all, at least until you figure out whats going on.
Thread
Thread Starter
Forum
Replies
Last Post
vingodine
5th Generation Classifieds (2000-2003)
45
05-21-2016 12:46 PM
flu2000
7th Generation Maxima (2009-2015)
5
09-08-2015 02:23 PM