Check my mevi wiring schematic please. (large pics)
05-20-2008, 10:49 AM
#41
ok im bumping this cause i was working on my MEVI today trying to get it to activate correctly.
To test my harlan switch I have it set at 2500rpms. I set it according to Wizards instructions on post 18 and I have it wired as shown in the pics in the first post. I rev my engine and it opens at 2500 as it should, however I keep revving and it then closes at 3000. I kept revving to about 5000 and it stayed closed. I let off the gas and it quickly opens and closes probably 5 times as the engine goes from 3000rpms to idle, then stays closed.
Anyone have any ideas why it wont stay open?
To test my harlan switch I have it set at 2500rpms. I set it according to Wizards instructions on post 18 and I have it wired as shown in the pics in the first post. I rev my engine and it opens at 2500 as it should, however I keep revving and it then closes at 3000. I kept revving to about 5000 and it stayed closed. I let off the gas and it quickly opens and closes probably 5 times as the engine goes from 3000rpms to idle, then stays closed.
Anyone have any ideas why it wont stay open?
06-03-2008, 09:44 PM
#42
Any updates?
How confident are you with how you have the vacuum lines connected? Double check them?
Did you program the Harlan for signal by coil? (button #1, dipswitch 5 up only)
How confident are you with how you have the vacuum lines connected? Double check them?
Did you program the Harlan for signal by coil? (button #1, dipswitch 5 up only)
06-03-2008, 10:08 PM
#43
Im still stumped
I have some time these next few days (only working 9am-1pm) so ill mess with it again and double check everything.
Thread
Thread Starter
Forum
Replies
Last Post
conansriver
5th Generation Maxima (2000-2003)
13
09-03-2015 06:38 AM