audio guru's please respond !
 

I'm installing 200watt pioneer amp with single 12" blaupunkt woofer using hugely "flamed" PAC SNI-35 ( just temporary )
The question is : should I tap after the rear speaker amp or before it ? or is it ok to try both ways and figure out which one sounds better ?
any info greatly appreciated !!!
V/R
Nick

anybody ???
 

any info would be great !!!!

You need to tap the wires between the amp and the speaker. This is so your converter can pick up the high-level (amplified) signal from the amps and change it into a low-level (RCA) signal for your sub amp. Don't even try tapping it into the wires before the amp, nothing good can come of it.

thanks a lot !!!
 

will do install next day , hepefully I will not blow any amps , fuses etc.
thanks again