WTB 2-channel amp
 

Need it to push 2 Orion 12's... Good Price please times are rough!! also pics... I live in NJ!!!

Thanks Guys!!!

What kind of Orions and what is the RMS wattage you are looking for? I have a JL Audio e1200 monoblock that is 2ohm stable and 275 RMS. It is a scratched up but works 100% I'm selling it for $80 shipped. I was using it on my 10w7 and it did a decent job while I was waiting for my 500/1. Let me know

thanks
Oliver

they are 500w RMS model 12D4..

can you send me a pic of the amp? shadow07080_1@yahoo.com

either get a 1000w RMS mono at one ohm (stable, mind you) I doubt you'll find an amp to do 500w by 2 @ 2 ohms..

hey, i use to be on this board when i had an i30. havent been on here in a while but i have two amps that might work. They are both brand new. I was going to use them for a setup i had planned but i am no longer doing that setup and am looking for a smaller single amp instead.

MB Quart RAA 2400 - will do 400rmsx2 at 2 ohm
MB Quart RAA 1000 - will do 1000rmsx1 at 1 ohm

i got a volfenhag ..1600 watt amp...2 channel **** is serious still connected in my car..$200 firm CLIK LINK FOR PIC...
http://www.b20vtec.com/forums/car-au...p-135-obo.html
* Amplifier Class N/A
* Number of Channels 2
* RMS Power (4 ohms) 300 watts x 2 . channels
* RMS Power (2 ohms) 400 watts x 2 channels
* RMS Power (1 ohm) Not Stable
* Bridged RMS Power 600 watts x 1 channel
* Peak Power Output 1600 watts
* Minimum Impedance Unbridged 2 ohms
* Minimum Impedance Bridged 4 ohms
* THD at Rated RMS Power 0.1%
* Speaker Level Inputs No
* Preamp Outputs Yes (1 Pair)
* Built-in Crossover Yes - HP / LP / Full
* High-Pass Crossover Frequency 50 - 1 k Hz
* Low-Pass Crossover Frequency 30 - 500 Hz
* Subsonic Filter N/A
* Signal-to-Noise Ratio N/A
* Channel Separation N/A
* Bass Boost 0 - 18 dB
* Bass/Gain Remote Yes
* Fan Cooled Yes
* Fuse Rating 40 A x 2

MTX 2300x will feed'em with around 300 per sub rms...