anyone do 2 dynos at once???
#1
anyone do 2 dynos at once???
I'm buying one of these regaurdless- for the scope and MIL capabilities alone
http://cgi.ebay.com/ebaymotors/ProSc...spagenameZWDVW
but I'm curious if anyone has put their car on a dyno and verified if these are accurate or garbage??? Same with the "virtual drag strip" software, garbage or worthy??
http://cgi.ebay.com/ebaymotors/ProSc...spagenameZWDVW
but I'm curious if anyone has put their car on a dyno and verified if these are accurate or garbage??? Same with the "virtual drag strip" software, garbage or worthy??
#3
Originally Posted by Hoooper
does that thing do work for a/f, timing or any of that other stuff that programmers like the emanage do?
Originally Posted by 5thgenmaxima
I'm buying one of these regaurdless- for the scope and MIL capabilities alone
http://cgi.ebay.com/ebaymotors/ProSc...spagenameZWDVW
but I'm curious if anyone has put their car on a dyno and verified if these are accurate or garbage??? Same with the "virtual drag strip" software, garbage or worthy??
http://cgi.ebay.com/ebaymotors/ProSc...spagenameZWDVW
but I'm curious if anyone has put their car on a dyno and verified if these are accurate or garbage??? Same with the "virtual drag strip" software, garbage or worthy??
#4
Your right. You can command a few egr components. But its pretty much for data logging. I'm getting ready to buy one for the scope capabilities alone, (maf and fuel trim/02) but I have been wondering about the so called "dyno" and "virtual drag slip". If anyone has logged this info and compared it to a time run or a "real" dyno???--I'm assumming the "virtual" drag slip runs off of laptop clock, and ecm's odometer so it would be fairly accurate, assuming the ecm shows in .01 seconds not .1????--I would assume someone here has used this with or without some accuracy?? I look forward to your reviews..
Thread
Thread Starter
Forum
Replies
Last Post
MaximaDrvr
7th Generation Maxima (2009-2015)
16
08-19-2015 08:20 PM
Nismo87SE
3rd Generation Maxima (1989-1994)
5
10-23-2000 08:15 AM