Power steering pump pressure hose
#2
I can't tell you if the 4th gen will fit but it is a very common problem on all the 5th gen cars. A junk yard hose may not be the best choice unless it looks like it's been replaced recently.
I took mine to a local place that makes and repairs hydraulic lines. They used the fittings and built a new line for a lot cheaper than a new one. Not as cheap as a junkyard part but essentially a brand new line.
I took mine to a local place that makes and repairs hydraulic lines. They used the fittings and built a new line for a lot cheaper than a new one. Not as cheap as a junkyard part but essentially a brand new line.
#3
I have read a lot of complaints about aftermarket pressure side hoses not allowing enough fluid to pass through the banjo bolt fittings. As a result, the owners experience power steering pump whine. So I would get my OEM hose repaired instead using an aftermarket. That is if I could not get a new OEM hose.
#4
What year is your car?
4th gens and 5.0 gens are the same AFAIK.
5.5 gens have a different harness connector up top. You can take this connector off and put a 4th or 5.0 connector on, and you'll be good to go.
So if you currently have a 2000 or 2001, you can find anywhere from 1995-2003 and make it work.
4th gens and 5.0 gens are the same AFAIK.
5.5 gens have a different harness connector up top. You can take this connector off and put a 4th or 5.0 connector on, and you'll be good to go.
So if you currently have a 2000 or 2001, you can find anywhere from 1995-2003 and make it work.
Thread
Thread Starter
Forum
Replies
Last Post
FenderGuy
6th Generation Classifieds (2004-2008)
3
08-17-2012 12:44 PM
nishfish871
5th Generation Classifieds (2000-2003)
10
09-07-2011 08:17 PM
MWM
5th Generation Maxima (2000-2003)
1
08-17-2010 08:17 PM