Jime's Garage Sale for MAXUS 09
 

This is a repost from the MAXUS for sale thread. I will be bringing this stuff to MAXUS 09. Shipping not included.

This is a start, I will be adding more as I get a little organized.

All come with Original boxes, Manuals/software.

1. Emanage Ultimate with complete harness. $425 SOLD
2. Emanage MAP Sensor and Harness. $70
3. SAFCII with mount. $130 SOLD
4. Transgo Shift Kit RE4F04A 93-99's. $35 SOLD
5. FJO Progressive Nitrous Controller Gen-2. $175
The PROGRESSIVE NITROUS MINI-CONTROLLER combines the functions of our 2-STAGE TPS AND RPM WINDOW SWITCH and our HIGH CURRENT SOLENOID DRIVER all into one very compact module. It can progressively drive two channels, each with a 40 amp load capacity (continuous duty). The device also supports low-voltage OEM, V10 or 3 cylinder TACH signals without the need for additional adapters. It works with most OEM throttle position sensors including most drive-by-wire vehicles. This device also includes FJO's "real curve" ramp which allows you to create a progressive curve instead of just a ramp, and the ramp can be either time based or RPM based. All this and only the size of a spark plug box.

Nothing required for install in all Maxima's, cable or drive by wire.

Check here for more info and manual. http://www.fjoracing.com/products/2s.../downloads.php
6. GTechPro Competition. $80 Original cost $359. Firmware upgraded to RR. Plastic Mounting bracket is cracked, replacement is $19.95.
7. Innovate OT-1, OpenTune OBDII/Can Interface. $125 Check here for details. http://www.innovatemotorsports.com/products/ot1.php
8. Innovate LC-1 Wideband Sensor Controller $100. Sensors are approx $50 available from Autozone, VW dealers etc. SOLD

PM sent regarding the EU

I'm interested in the SAFC-II. What is your paypal?

About the wideband controller, Of course I'll need to get the wideband o2 but will I also need to get a sensor controller or can that be done via laptop and software?

Wowzers, you're still here?

yeah, missed you two...

You just need to get a sensor. It connects via serial (9 pin) connector which is included as well as software (Logworks 2).

However there is newer software available from their site.
http://www.innovatemotorsports.com/support.php

how old is that shift kit? is it the newer (upgraded) one? does anything in the kit need replacing? thx

also is the $35 shipped or +shipping?

very nice deal....

I bought it 1 year ago. All parts still in original plastic pouches unopened. Not sure if its the upgraded one, probably not.

$35 if you pick it up at MAXUS 09, otherwise + shipping.

01 MAF in my 02
 

Jime,

Can you forward any pictures on how to transfer the Thermister?

Tks,

Bob

Ahh, so with this cable, the sensor, the software and a vafc2 I'm all set adjust my af ratio?
If it's a dumb question, sorry, been out of the game for a bit...

You have it. You can also get a gauge but they aren't much good to adjust your a/f, you need logging capability which your laptop will give you.

Bob I don't have any pics but it looks just like a resistor with a wire on each end that clips in. You just need to remove it from the 02 maf and put it in the 01.

you got yourself a sale then. I'll paypal you later tonight and then I'll pick i up a maxus from ya, how does that sound?

Dave you can just pay me then, I will hold for you.

Jim

I'd rather do it now. Not just to reserve the item but also cause I'm not planning on bringing that much cash with me to DC. Just a bank card...

[quote=DAVE Sz;7059225]I'd rather do it now. Not just to reserve the item but also cause I'm not planning on bri

Ok np I'm easy.

ok, sent. Sorry for the delay.

np, see you at MAXUS.