I just ordered some replacement parts for the rear suspension and I was just wondering if I bought the correct item.

I have the Motivational mounts and was wondering if this is the "rubber ring" they are talking about.

 

Yes that is, install it just like you see it in the pic. The cutouts in the motivational mount should fit the top stuff sticking up, and the spring sits on the bottom

 

... overall I am very happy with the way my rear suspension performs having installed B&G springs, AGX struts and the motivational mounts. One difficulty was that both the ribbed and stock rubber washers are too wide to both fit on to the threaded upper end of the rear strut. I ended up using only the ribbed rubber washer and the upper gold washer. Maybe it was due to using new uncompressed bushings. I don't think it makes a difference at the top just so you get it tightened down all the way. Be Safe, Mark V.

 

I used an extra Energy Suspension urethane washer in place of the ribbed rubber washer. I'm happy with my setup...Mike gave me an extra set of the washers and sent me on my way.

 

Yeah I'm getting rear suspension noises on average to relatively big road imperfections. It's sort of a clunking noise. Anyway, my rear suspension bushings were shot so I ordered 2 new top nuts, 2 new gold washers, 2 new ribbed rubber bushings, 2 new double rubber bushings, and 2 new big "rubber rings" as shown in the pic. Hopefully this wil silence it up.