saw this on ebay.. anyone have knowledge/access to the maf plug cost/availability? group buy? thomas??

http://cgi.ebay.com/ebaymotors/ws/eB...tem=2427588705

 

when we bought the Z32 MAF for my friends turbo 3rd gen all we did was rewire the harness to the Maxima harness, no need for a special harness(unless your Z32 MAF came without one)...these are the directions from JWT in PDF--> http://www.sr20development.com/Instructions/Z32-MAF.pdf

EDIT...and if you do need a harness, guys on TT.net parting out, usually let them go for $10-15.

 

I know that but thought I would take a chance.. perhaps if it wasn't too expensive (oxymoron.. japanese tuner reasonable) it would be worth getting a new harness instead of someones i don't know what..

 

i'm looking into it. i'll let you know when i find out.

 

cool... thanks thomas!

 

www.TT.net appears to be the address of an ISP. What did I do wrong?

Edit: I tried twinturbo.net, that worked.

 

That page says it shows the pins "viewed from the harness side of the plug". That's just a bit ambiguous to me. Does that mean you are holding the harness and looking at the pins in the plug? So it's the mirror image of looking at the pins in the maf, right?

 

as for the diagram and install the Z32 harness my advice is to lay it down on a table(plug side facing you and wire lengths facing away like in the PDF picture), label each wire(pwr, signal, etc.)...next go to your Maxima and label the corresponding wires...then of course wire it up. this is how we did it, only reason this might seem drawn out is because if the wires are wired in wrong...say bye bye $600 ECU according to Clark at JWT!!!

 

Oh good Lord you've got me scared now.

 

Like this? http://www.phase2motortrend.com/tomz32masplu.html

 

I looked on my Z32 maf and the pins are labelled A B C D E F just like in the pdf, so there is no ambiguity. I feel much better now.