I couldn't find the eraser (rubber) drill bit so I made one- THE GHETTO WAY .I went to Sears hardware and picked up a medium size rubber spindle for a spindle sander then used the dremmel and cut it in half. After I took a cylinder shaped grinding stone drill bit and stuck it in the end of the rubber spindle hole. Got the drill and went to work on the glue!! Came off but take your time with it because the drill and rubber were moving so fast if it rubs too much on the same spot the rubber starts to heat up and starts to stick to the paint a bit. I did it slowly and the glue pretty much came off nicely. Even debadged my friend's Altima while I was at it. Now I just have to clean off the excessive rubber and buff the glueless area. It took me about an hour and a half .

 

great job!!!!!!!!!!!!!!11