Hey guys, Anyone with a 4th gen, V2, 3.12 pulley, vortec fmu,jwt ecu, have the safc settings from after they DYNO'ed? I had to jumpstart my car and it wiped my safc out. I have it back to where it is running decently but i was wondering if anyone could help me...

Thanks!

 

SAFC II just wanted to specify

 

if u cant find these settings, jay has settings for everything u have except no JWT ECU and a 3.25 with CAI ( 10 psi ). its in the FAQ section...hope this helps if all else fails...

 

What size disk? What size injectors? What's your base fuel pressure?

There are too many unknowns involved here.

 

8:1 disk stock injectors, no Fuel pressure guage, JWT ECU. Right now I have it set at:

2k 2%
3k 4%
4k 6%
5k 8%
6k 11%


I do not have a MEVI. and as far as I know i do have stock injectors, but i was told they were replaced and they may be 370... but i dont know. They are red if that helps.

 

Red injectors are stock. I don't think there are any red 370's. I take it your JWT ecu is programmed for NA?

 

Testing. An' a one an' a two ....