Tatanko's Christmas Thread 2007
Tatanko's Christmas Thread 2007
Since I've done a Christmas thread the last two years, it's time for this one! What is your Maxima getting for Christmas this year?
Mine is somewhat disappointing. I'll be glad when it's done, but no "mods" per se:
-Wiper blades
-Fuel filter (Z32)
-Spark plugs
-Brake pads and rotors
-One new rear coil pack
-New Bose front speaker (replace blown one)
-Air filter
-Timing chain tensioner
-Port matched intake manifolds
-EGR pipe install
Boooorring
What is yours getting?
Mine is somewhat disappointing. I'll be glad when it's done, but no "mods" per se:
-Wiper blades
-Fuel filter (Z32)
-Spark plugs
-Brake pads and rotors
-One new rear coil pack
-New Bose front speaker (replace blown one)
-Air filter
-Timing chain tensioner
-Port matched intake manifolds
-EGR pipe install
Boooorring
What is yours getting?
Last edited by Tatanko; Dec 22, 2007 at 09:05 AM.
I'll play since I don't hang out in this are much anymore.
-Spark Plugs
-IACV install
-Intake install since I'm running TB-MAF-Filter right now
-VAFC Tune
-TIRES!
-Camber adjustment and alignment
-Hopefully an Ionic Dynamics lip kit
Merry Christmas!
-Spark Plugs
-IACV install
-Intake install since I'm running TB-MAF-Filter right now
-VAFC Tune
-TIRES!
-Camber adjustment and alignment
-Hopefully an Ionic Dynamics lip kit
Merry Christmas!
- Minor adjustments in front suspension/tie rods.
- EARLY gift woodgrain pop out tray.
- EARLY gift woodgrain switch covers.
- Oil/Filter change. (LOL)
- Leather protectant I have been putting off.
- Keeping my DRUNK self OUT of it.
Everybody have a safe and happy holiday!
- EARLY gift woodgrain pop out tray.
- EARLY gift woodgrain switch covers.
- Oil/Filter change. (LOL)
- Leather protectant I have been putting off.
- Keeping my DRUNK self OUT of it.
Everybody have a safe and happy holiday!
Member
Joined: Oct 2007
Posts: 180
From: Worcester
ummmmm....if my car isent tolaled
-spark plugs
-plug wires
-oil change
-clear bumper lights
-windshield blades
-HID kit.
-5% tint rear and not sure front
now this is only if my car is fixable ......Wish me luck
if my car is tolaed.
-A NEW MAX.
-spark plugs
-plug wires
-oil change
-clear bumper lights
-windshield blades
-HID kit.
-5% tint rear and not sure front
now this is only if my car is fixable ......Wish me luck
if my car is tolaed.
-A NEW MAX.
Last edited by BiZzL3; Dec 22, 2007 at 10:45 AM.
she got:
Es motor mounts
Es control arm bushing set.
New L.E.D. mirror covers from paradox (when I get in contact with Harry and finish the order)
A full Stealin skirt kit
New Clutch that is sitting on the floor waiting to go in.
1/2 size rear window spoiler that is waiting on paint and warmer weather to install.
I think that's it.
What did I get? Nutin' and that's ok. I asked the wife to help me spoil the car.
Es motor mounts
Es control arm bushing set.
New L.E.D. mirror covers from paradox (when I get in contact with Harry and finish the order)
A full Stealin skirt kit
New Clutch that is sitting on the floor waiting to go in.
1/2 size rear window spoiler that is waiting on paint and warmer weather to install.
I think that's it.
What did I get? Nutin' and that's ok. I asked the wife to help me spoil the car.
Last edited by JSMax; Dec 22, 2007 at 11:24 AM.
I'm in the midst of a major 120K service (even though I'm only at 117K)
-CV Boot Rebuilds
-Amsoil GL-4 Gear Oil
-ABS Sensor
-NGK Platinum Spark Plugs
-PCV Valve
-Z32 Fuel Filter
-Rebuilt Rear Calipers + OEM Pads
-Oil Change
-Shifter Bushing
-Reset SES light from O2 Simulator
After all that's done, it's back to the fun and games....
-'00VI
-VAFC
-Progress/Illuminas
-18" Mille Miglia Evo5's
-Tints
-CV Boot Rebuilds
-Amsoil GL-4 Gear Oil
-ABS Sensor
-NGK Platinum Spark Plugs
-PCV Valve
-Z32 Fuel Filter
-Rebuilt Rear Calipers + OEM Pads
-Oil Change
-Shifter Bushing
-Reset SES light from O2 Simulator
After all that's done, it's back to the fun and games....
-'00VI
-VAFC
-Progress/Illuminas
-18" Mille Miglia Evo5's
-Tints
What does that mean?
Joined: Apr 2007
Posts: 392
From: Calgary, AB
-new hood struts
-new o2 sensor
-new cabin filter
-new screw for one of the coils
it got lost in the depths of the intake manifold (outside the engine!)
-possibly clean up of the throttle body and area
-possibly new thermostat
-possibly new knock sensor
-possibly upgrade bulbs
Other than a small rust patch behind a rear well, and a cracked windshield, car should be 100% after these repairs
1996 GLE w/133k miles 214 k kms
-new o2 sensor
-new cabin filter
-new screw for one of the coils
it got lost in the depths of the intake manifold (outside the engine!)-possibly clean up of the throttle body and area
-possibly new thermostat
-possibly new knock sensor
-possibly upgrade bulbs
Other than a small rust patch behind a rear well, and a cracked windshield, car should be 100% after these repairs
1996 GLE w/133k miles 214 k kms
all done today....
1) Installed clear corners with locking house (nuts and bolts, as opposed to the nipple).
2) Sawed off the foglight area plastic wings.
3) Installed 4 Brembo sport blanks and 8 Akebono PRO-ACT Ceramic pads.
4) Replaced compressor serpentine belt.
5) "Installed" MAXIMA.ORG sticker.
6) Installed RAIN-X 20'' wiper blades.
7) Swapped driver's side HomeLink visor.
8) Vacuumed the mats/seats.
9) Full interior detail/conditioned leather.
10) Superglued two rattling window switches.
11) Magic Erasered all 4 sawblades.
1) Installed clear corners with locking house (nuts and bolts, as opposed to the nipple).
2) Sawed off the foglight area plastic wings.
3) Installed 4 Brembo sport blanks and 8 Akebono PRO-ACT Ceramic pads.
4) Replaced compressor serpentine belt.
5) "Installed" MAXIMA.ORG sticker.
6) Installed RAIN-X 20'' wiper blades.
7) Swapped driver's side HomeLink visor.
8) Vacuumed the mats/seats.
9) Full interior detail/conditioned leather.
10) Superglued two rattling window switches.
11) Magic Erasered all 4 sawblades.
I've got all week open to working on the max...
-00vi
-knock sensor (freee
)
-fidanza flywheel
-fidanza 4-puck kevlar clutch
-ss clutch line
-amsoil gl-4
-driver's side cv boots
-new wipers
-spare tire cover
-battery terminals
-oil change
-fuel filter
-evap canister to fix CEL
-much needed bath
happy holidays everyone!
-00vi
-knock sensor (freee
)-fidanza flywheel
-fidanza 4-puck kevlar clutch
-ss clutch line
-amsoil gl-4
-driver's side cv boots
-new wipers
-spare tire cover
-battery terminals
-oil change
-fuel filter
-evap canister to fix CEL
-much needed bath
happy holidays everyone!
Last edited by mowgli29; Dec 22, 2007 at 08:18 PM.
oil change
z32 fuel filter (if I can get one)
wash
through out the whole year it has gotten
5spd swap w/ rebuilt trans
lowered on gr2 and h-tech
progress rear sway bar
FTSB
knock sensor
y-pipe
new tires
z32 fuel filter (if I can get one)
wash
through out the whole year it has gotten
5spd swap w/ rebuilt trans
lowered on gr2 and h-tech
progress rear sway bar
FTSB
knock sensor
y-pipe
new tires
00vi going in! FINALLY! Haha...(oh, and Tatanko, its port matched :P)
Um, detailed
DR Mod
Rad fan switch
New floor mats
(early january):
Tranny cooler
Amsoil ATF
Lucas tranny stuff
Maybe new rotors and a brake bleed
I almost bought a 3.5 if that counts for anything...
Oh, and MERRY CHRISTMAS!!
Um, detailed
DR Mod
Rad fan switch
New floor mats
(early january):
Tranny cooler
Amsoil ATF
Lucas tranny stuff
Maybe new rotors and a brake bleed
I almost bought a 3.5 if that counts for anything...
Oh, and MERRY CHRISTMAS!!
Nada (maybe an OBD-II scanner). This Christmas I'm getting parts for my NEW baby:
Intel C2D E6750 w/ ArcticCooling HS, OC'ed to ~3.4ghz
Gigabyte mobo w/ P35 chipset
4GB ram
Radeon HD 3870
mushkin 580W PSU
XP Pro x64 edition
Intel C2D E6750 w/ ArcticCooling HS, OC'ed to ~3.4ghz
Gigabyte mobo w/ P35 chipset
4GB ram
Radeon HD 3870
mushkin 580W PSU
XP Pro x64 edition
-Just got a Vafc II for the 00vi, going in prob in jan-feb (MOHFpro i'll b picking your brain, lol)
-Hoping to get a PLx-m300 before new years.
-Tranny cooler
-october re-did head gaskets, all seals, o2's, etc. (she's happy)
-Jan-> install my junkyard find on 00vi...PR cai for $20 bux including the MAF
-fluids next monday
Happy Holidays to all my org brothers and their families
-Hoping to get a PLx-m300 before new years.
-Tranny cooler
-october re-did head gaskets, all seals, o2's, etc. (she's happy)
-Jan-> install my junkyard find on 00vi...PR cai for $20 bux including the MAF
-fluids next monday
Happy Holidays to all my org brothers and their families
Oh, and that doesn't make it okay that your server still isn't up When are you and I going to organize a State College Max meet? There's at least 4 .org members here.
-A nut for the b-pipe hanger (speaking of does anyone know what size that is? I think its 12mm)
-Fog lightbulb(s)
-Gas
-I think it'll need a new shift ****.
I think I'm done with the maxima, I'm saving up for something else, something more track worthy.
-Fog lightbulb(s)
-Gas
-I think it'll need a new shift ****.
I think I'm done with the maxima, I'm saving up for something else, something more track worthy.
