UPDATE 9-14. GOT VIDEOS UP CAR IS UP AND RUNNING,HAVE A LOOK

The car at this time is complete but not drivable, problems are needs brakes. either master is bad or calipers,will need all 4 tires.

Car now runs and drives check out videos,just needs brakes.


The car has been a yard ornament for the past 5 years so it starting to show some wear, with that said its time for me to part ways with it.Thing i'd really like to sell first is the engine as this is fully built and everything is brand new in it. ASKING 1200.00 FOR THE ENGINE.

Note: I belive the vtec solenoids are starting to go,when the car is warmed up it makes a slight ticking noise then goes away.Of course could just need to change the oil as its has been sitting for awhile.

After that doesnt matter what sells,most likely will be going to the junkyard. If nobody buys the whole car that is.

Some info on the car:
Location:St.Petersburg,Florida

Car specs:1992 maxima SE 5 Spd VE30DE motor,black exterior,grayish black stripped cloth seats,black carpet,door panels etc.
Car History:Since purchasing it I have slowly built the car over the years,keep in mind when i started modifying the car,parts are nothing like they are today.I think stillen had a 4 page catalog and most of it was for the TT 300zx.On with the modifications.
Motor has been bored .20 over with 11:8 compression JE Pistons (if memory serves me correctly) with eagle rods.
Engine fully balanced
Crankshaft has been fully balanced and lightend
Heads,exhaust manifold have all been extrude and honed
Heads have been fully rebuilt new (OEM valve seals, springs,retainers,valves,camshafts,lifters)
every seal,gasket has been replaced
new knock sensor
everything for the timing has been replaced new chain,sliders,etc
Transmission rebuilt
Stillen lightweight flywheel
Stillen stage 3 kevlar clutch
New cv axles
Tokico struts w/ eibach prokit springs at all 4 corners
Suspension technique front and rear sway bars
Stillen rear cross drilled rotors
Stillen short shifter
Stillen Intake
Real Carbon fiber interior dash kit,complete covers all doors,a/c vents etc.
Touring spoiler
Greddy catback
Upgraded Y-Pipe
Jim wolf ecu upgrade
ASP aluminum underdrive pulley
Catz MSP fog lights
Canton racing high flow fuel filter
Canton racing oil filter
Some before engine assembly,now pics

http://groups.msn.com/mitsubishiandn...issanpics.msnw


Below links are as the car looks today

http://s65.photobucket.com/albums/h2..._tab_my_albums

http://s65.photobucket.com/albums/h2...cing/?start=20

Any other questions ask away.


VIDEOS 9-14-08 just to keep em at the top: details in post a little lower in thread.

http://www.youtube.com/watch?v=5UOv9baZMKo


http://www.youtube.com/watch?v=cP509sAZX5M&feature=user

 

How much for the JWT ECU shipped to 32086?

Oh, and how much for the front+rear stabilizer bars? I take it the bushings are still good?

 

Interested in the pully...

is it underdrive(some people call it an underdrive even thought it might only be lighter) or lightened (the aluminum)?

or its actually a lightened underdrive?

shipped 32905, or if your going to the SFMG in miami i could meet you there we will see

thinking about your used suspension too, how long have you had it?

 

How much for the springs?

 

350.00 shipped for the ecu

180.00 for both.Bushings should still be good as they are polyurethane.


Dont think ill be going to the meet.This is a ASP aluminum underdrive pulley I'll throw in the belts for free. 75.00 shipped

Suspensions been on the car for about 6 years,but as mentioned cars been sitting for 5 and last time i drove it still felt like it was on rails,no noise,very smooth etc

springs 125.00.

225.00 for everything but i would need yours so it can be put on tow truck

 

UDP is sold to me PM sent

 

pm sent...

 

how much for cv axles?

 

all pm's replied to.

Thanks for all the interest guys,For right now the car is on hold for parting out,have a potential buyer for the whole car complete.

 

how much for the tranny shipped to 37076?

 

pm sent

 

Dare I ask how much the parts required for the 5 speed swap would be?
(http://forums.maxima.org/3rd-generat...ap-sticky.html)

I'm local so I can make the trip over to St Pete to pick it up if I can find the dough.

 

Videos Are up.

1st video cold start up after sitting for 5 years, thats 5 year old plugs,fuel filter,intake filter etc:

http://www.youtube.com/watch?v=5UOv9baZMKo

2nd video backing it out of its crypt after 5 years:

http://www.youtube.com/watch?v=cP509sAZX5M&feature=user

Doesnt have brakes remember so i couldnt give it much gas but i did shift into second.

As you can see it runs and drives.Now who wants to buy the whole car.

Enjoy

 

everything back up for sale?

 

Not quite yet, Should know by Wednesday if whole car is sold.

 

let me know if youll let go of the exhaust. im right down the street from you.

 

Mods go ahead and lock this thread please,I have decided to keep the car.

CAR IS NO LONGER FOR SALE

Thanks for everyone's interest in the whole car or just the parts. Perhaps once i get it back to where it once was i'll get to the dyno and post up the numbers.