It has all of the California emissions junk. I'm taking it off of the new one because I don't need it. The motor has around 250k. I had it apart in the last couple weeks and all the tolerances and specs were very tight within factory limits. Virtually no wear on the internals. The heads are straight with the seats just ground.
There are way too many parts to list really.

just text me at 281-690-1904 or PM me on here but it might take a little bit to respond. I know the condition of most of the parts but if you get one that is faulty, I will refund your money. Nothing sucks more than paying for a broken part.

 

Bump for being totally broke and 2g's in the hole. I also have 3 brand new coil packs, platinum NGK plugs with 15 minutes of run time, and a water pump with 15 minutes of run time.

 

so what happen to it

wtb MAF for a 96

 

I bent a few of the oil rails when I put the pistons back in the first time so I had some blow by, and the bastard wouldn't run. I'm also pretty sure that my ECU is bad and that had something to do with it. I was so damn pissed at that point it was either roll the car into lake hefner of get a different motor.

 

I'm going to start tearing down the motor tonight and will have detailed pictures of integral parts of major components.

 

how much for the coil packs shipped to 19120?

 

$200 3 of them were used for maybe 2 or 3 days.

 

I take that back. $40 a piece for the new ones (paid 70 ea.) $10 a piece for the old ones, but they are still good. So $150 for the set.

 

Ugh, I'm in a pretty tight spot with money so I'll take any reasonable offer on motor parts plus shipping. I'll take pictures on a part by part basis. I'm entirely too lazy to sit outside all day washing parts and taking a couple hundred pictures. On the upside though, in Oklahoma a block and various other motor parts in trash bags on your front porch probably increases the property value.

 

Bump for any reasonable offers, and I'll take full or partial trades. I definitely need parts, just not any that I currently have. haha

 

bump

 

bump

 

bump

 

Do you know if the connecting rods are the same as the ones in the 300ZX VG30DE? I mean are the small ends of the same diameter. If so, how much for your con rods shipped to 23702?

Jose

 

I have no idea if they are the same. You would have to do a little bit of digging. If they do fit you can have them for 80 shipped. I would hurry though. When i get the time I am planning on using the block and 4 of those rods to make a coffee table.