Hi

Recently my idler pulley blew up after siezing so I bought one at an auto parts store. They only provided the pulley itself and it appears there are two parts missing that act as washers to keep the pulley separated. Dealership no longer carries them. Picture below on the parts. Let me know if you have them.

 

No one parting an engine these days? A bit surprising.

 

Found mine on the floor next to a max a junkyard was going flick at a car, took it instead and whent to the dealer found out it was exactly the pieace i needed very thick washer thr bearly moves the pulley away from the adjuster

 

I'm still looking for these parts. PM me. I'll pay a good amount for these low-value parts.

 

the two washers? I think I have 'em, but I'll have to check in the morning.

 

I'm sure I have them too and will verify later. You can contact me if Ben does not have the peices.

On a side note, to facilitate finding parts you need, I suggest that you skim the FS threads. I know personally I've had a FS thread regarding numerous 3rd gen parts for a very long time on the first page, as have others. Not sure about others, but I don't often check the WTB threads.....and might be why you've not gotten more responses.

 

I have the complete assembly with the adjuster bolt. So you only need the two washers and neither of the plates?
Let me know if Ben doesn't come through.

 

Yea I have been sending inquiries with FS threads as well. This looks different than my model's assembly -- what year is it for?

 

It's for the VG engine. Doesn't matter the year, they are all the same.....no design change.

What do you think looks different? May just be the angle.

 

I have a VE (1993 SE)
my pulley is not flat on the edges, instead it has a grooved black piece. I can send a picture later.

Might want to PM me -- subscribe isn't sending e-mail notifications to me somehow.