Looking to buy a set of Roderick RW6 20x8.5 fronts and 20x10 rears. They make 2 different sets with 5x114.3.....offsets of .20 front/ .20 rear, also .35 front/ .40 rear. Which set will have the more concave look to it(loving that)? and will they fit without sticking out or best opinion on clearence??? Please help, this is my last step to buying them.

 

Nice wheels, but one size set is too much and too little, the other is too little too much.

those are pretty commonnow almost as common as the bbm LM...replica that is. The bbs lm replica r so common now that people dont call them bbs lm replica no more, people just call them bbs LM.

maybe u should look into getting the bbs LM ? So much for intellectual property.

 

.35 front/ .40 rear go with this offset in my opinon.. and go with 245/30-35/20 on tire all around anything wider then that might rub

 

Bbmaxi...when u say too much an too little, which is which? Does the .20/.20 have a deep concave rear and will those fit our car? or the .35/.40? Which exactly has a slight concave front and deeper rear and will fit our car without sticking out past the car, thats the set i want.

These are the wheels and the look of them i like

http://mbworld.org/forums/w211-amg/4...part-deux.html

 

The width of the wheel determines the amount of concavity more than the offsets.

 

Most 1pc wheels have one mold per size and the pad depth determines the offset. Therefore the concavity is the same.