Just got a Greddy SP exhaust for my 95SE. Problem is, when the muffler shop was installing it, I noticed that it had an O2 sensor hole. when it was fully installed, the muffler tip stuck out some 2 1/2 inches out past the bumper! It doesn't look good! Obviously, I received a 97-99 cat-back exhaust instead of 95.

No biggie. The shop put a o2 sensor plug in, and tomorrow, I will go back to get the tip shortened. The actual polished tip is connected to the muffler by a short piece of pipe--it shouldn't be too hard for them to do.

Q: how far does the tip extend on you 1995-96 Greddy cat-back? Is it flush with the bumper, slightly in or slighty past? I want to get it to what it should have been.

Thanks

 

I believe the Greddy exhaust sticks out .5" - 1" past the bumper.
-Cyrus

 

The 0.5 to 1 inch sounds about right. I have a '99 with the SP exhaust. I'll get the tape measure and be back in a few minutes. I also had to plug the extra sensor hole. But my mechanic didn't have a plug so he just welded it. Works for me. Hang on a minute while I find the tape measure.

 

The tip sticks out about 1.5 inches from the lip of the bumper that is directly above the tip. It is about perfectly flush with the true end of the bumber that is several inches higher.

 

A big THANK YOU!