i want to run the power and audio cords for my amp and the only way i can see doing it is run the wires down the side and under the rear seat. so if anyone can please let me know how to pull it out its a 91 brougham

Thanks
Optimus

 

the lower part of the seat comes out by just putting your fingers under it and pulling up hard; there are 3 or so clips that will pop out. That part then pulls out. Now you will see a hook and screw on each side for the upper part. Take those out. Behind the armrest, there are 2 screws covered by little trim pieces that pop off with a screwdriver. Once those are out, pull up and the seat will pop out of the 3 clips at the top. You probably dont even need to take out any screws or anything and just take out the bottom for what you're doing though
let me know if this doens't make sense