I'm parting out my beater 95 GXE 5-speed today guys. I'm not gonna strip every little piddly part off of it in the hopes of selling it, but if there is something specific that you need that is worth my time to take off and sell to you, I'll look and see what's good.

9 Month old starter available. $80 shipped OBO.

Basically all body panels are bad including bumpers (unless you felt like repainting them).

Interior gone

Suspension is totally shot, I don't think anyone would want any suspension components.

Remanufacutred Alternator good and less than year and a half old $90 shipped

coilpacks good (I have two sets, 12 coilpacks, from this max and my other previous max) $70 shipped for set of 6

injectors all working good and I'll even throw in an extra brand new deatschwerks one I have if I can find it (I have it around here somewhere) $70 shipped

Keep checking this thread because I'll keep editing the original post as I think of other stuff that is good

edit: some more misc things that are available.

headlights (glass is good, but a couple of the mounting studs were corroded and broken off) $40shipped for set or $25 shipped each one

taillights, passenger side turn signal

TWO sets of coilpacks (from this car and a previous max) all working $70 shipped for a set of 6

the huge dash harness and chassis harness with associated fuse box and relay boxes, all fuses and relays working - make offer on each harness

TWO ignition harnesses brand new one was used for about 6 months one was purchased for my other max and never even installed (discovered the problem I was having was something else) $25 shipped each one


crank ref and crank position sensors (CPS REF, CPS POS) I think I have multiples of these from various VQ30s I've had over the years. $20 shipped per sensor contact me so I can figure out how many i actually have, I have multiples

CAM position sensor $15

TWO throttle bodies each with TPS sensors $45 shipped or will sell TPS sensors separate for $20 shipped


TWO upper intake manifolds (USIM) $45 shipped

TWO IACV valves $40 shipped

TWO lower intake manifolds$30 shipped

good A32 MAF $45 shipped

one set of stock size Deatschwerks fuel injectors, cleaned flowed and balanced, never installed still sealed in bags $140 shipped

one set of used stock injectors all working well still in 4th gen fuel rail$70 shipped

THREE interior door pulls (the thing you pull on to close the door) $10 shipped each

arm rest top (not entire center console assembly, just the arm rest part). $20 shipped

manual climate control (I can't remember if the LEDs work or not since it's been like 6 months since I've really driven this max and I have 3 maxes so I can check and see if they work, otherwise you can replace them with custom colors easily, there is a writeup on the .org) $35 shipped

Single din change tray with flip lid $20 shipped


all 4 door panels black with gray cloth (not great condition, definitely not for a show car but not terrible) will let these go cheap but shipping would be a bit expensive so prefer local pick up in Chicago or Western michigan or northern indiana make offer will probably accept as long as I don't have to ship

all window switches working $20 shipped

driver's door window/door lock switch panel $25 shipped

driver's side door harnesses (both front and rear) intact (passenger side not available I cut those ones before deciding to take the time to actually remove the driver's side harnesses intact). make offer

passenger side window switch harnesses (front and rear) snipped with plenty of wire length to splice in to yours if needed $10 shipped or will throw in with window switches

rear dashboard center taillightsold

will add more as I remember other stuff I've removed.

edited post and lowered some prices.

 

if its an 5MT ill grab that shifter trim.
black.

 

what year? 5spd?

 

95 GXE 5spd.

Trans I am most likely going to sell locally.

 

95 GXE 5spd.

Trans I am most likely going to sell locally.

 

I've got things like entire center console out (radio and climate control and vent area I mean, not the arm rest.)

turn signal stalk and windshield washer stalk (single speed intermittent, not the variable speed intermittent wiper like SEs and GLEs have).

All door panels are out. All window switches, motors, tracks and pulleys are out. Windows themselves are out. Headlights and taillights are out. 5spd shifter trim is out.

 

alright shoot me a PM about the shifter trim. ill take it.
oh and if your armrest is free of cracks ill take that to. mine looks terrible..

 

What color is the car?

 

Pearl white.
Arm rest looks fine but I think the hinges are broken if I remember correctly, I will check it tomorrow (car's up on a lift right now high in the air).

I'll get ahold of you tomorrow or monday about the shifter trim. I'm still working on the car about to give up and head home and come back tomorrow and work on it some more.

 

button\slider from climate control??

 

yes I have that, but I am not sure if all the LED lights to illuminate the buttons work. It's been so long since I've driven this car I can't remember. I've driven the car once in the past 6 months or so.

those lights are replaceable there are write-ups here on the .org on how to do it, let me know if you want it still.

 

alright, no rush,just irritating about my cigg lighter falling out, and i have working hinges so i wont need em.
wait, you can replace hinges right?

 

Are you willing to part out the radiator condenser fan? and ship it? let me know

 

let me check on condition of fan shroud, the fan on passenger side is missing but I don't know if the shroud itself is OK or not. will post back.

edit: just removed fan shroud. there is a little chipping where one of the 3 bolts that bolts in that bolts in the passenger side fan to the fan shroud goes. if your existing fan shroud is broken this could be a replacement. it's not perfect but it would work, you'd just have to put a passenger side fan in the shroud. i ran for 5 years without a passenger side fan and never had a problem, so you might not even need to put the fan in if you don't want to.

I don't know about the hinges haven't looked at that part yet. will look and reply in a little while.

 

Willing to sell the two oxygen sensors on the y pipe before the cat? and is the car stock?

 

yes the car is stock. i'll try to get at the O2 sensors and let you know.

 

door interior color?? i need tan inserts for front doors

 

Could use rear calipers. We're urs rebuilt/replaced or are they originals?

 

rear calipers are bad (stuck) you would not want those.

interior is gray not tan, sorry.

got the part out done today guys, ended up taking off a lot more parts than I originally intended to (kind of got sucked in to the moment) so if there is something you need just ask.

 

Rear calipers unless they r the originals

 

how much for the control arms

 

control arms are shot, ball joints bad (rust and worn out). all suspension components are useless on this car. stuff that's good mostly includes sensors, stuff from engine bay, stuff from inside the cabin.

 

some misc things that are available.

headlights, taillights, passenger side turn signal.

TWO sets of coilpacks (from this car and a previous max) all working

the huge dash harness and chassis harness with associated fuse box and relay boxes, all fuses and relays working

TWO ignition harnesses brand new one was used for about 6 months one was purchased for my other max and never even installed (discovered the problem I was having was something else)

alternator (new within last 2 years)

crank ref and crank position sensors (CPS REF, CPS POS) I think I have multiples of these from various VQ30s I've had over the years.

CAM position sensor

TWO throttle bodies and TWO TPS sensors

TWO upper intake manifolds (USIM)

TWO IACV valves

TWO lower intake manifolds

A32 MAF

one set of stock size Deatschwerks fuel injectors, cleaned flowed and balanced, never installed still sealed in bags

one set of used stock injectors all working well still in 4th gen fuel rail no broken pintle caps all good

THREE interior door pulls (the thing you pull on to close the door)

arm rest top (not entire center console assembly, just the arm rest part).

manual climate control (I can't remember if the LEDs work or not since it's been like 6 months since I've really driven this max and I have 3 maxes so I can check and see if they work, otherwise you can replace them with custom colors easily, there is a writeup on the .org)

Crutchfield single DIN change tray with flip lid

gray flip down visors/mirrors (non-lighted)

all 4 door panels black with gray cloth (local pick up only at this point, decent but not great condition, definitely not for a show car) will let these go cheap.

all window switches working

driver's door window/door lock switch panel

driver's side door harnesses (both front and rear) intact (passenger side not available I cut those ones before deciding to take the time to actually remove the driver's side harnesses intact).

passenger side window switch harnesses (front and rear) snipped with plenty of wire length to splice in to yours if needed

rear dashboard center taillight

will add more as I remember other stuff I've removed.

 

No O2 sensors?

 

you didnt grab my armrest OR the shifter console? not good salesman ship man.
ill need the center taillight though.

 

You have the o2 sensor from the cat? The one from the bottom of the car. Let me know if you have it and price shipped to 80003.

 

I grabbed both dude. I am just listing things as I remember them. I'll get you pics in the next day or two. Kinda busy right now and I do most of my posting from work. Still gotta unload a bunch of crap that is just piled inside my car.

 

nope didn't bother to grab O2 sensors couldn't get the y-pipe off and totally forgot to grab the rear one.

 

I'll sell you the entire climate control module, I'm not going to take it apart and sell a piece of it if that's what you mean. $25 shipped if you're interested.

 

Nope sorry couldn't get the Y pipe off easily and then moved on to other things and totally forgot about them.

 

I was wondering if you had the upper intake manifold? How much for the iacv, throttlebody, manifold, and egr tube if you have it?

 

I do not have the EGR tube, however I do have the rest of those (multiple examples of them actually). $100 for upper, IACV, TB.

 

do you have the front engine mount bracket(closest to radiator)?

 

9 Month old starter available. $90 shipped OBO.

 

i'll take the driver side headrest if its in good shape. i've been looking for a gray one for a bit.

 

Neal do you have the gauge cluster surround trim?

 

It was in good shape, but the interior got hauled off to the junkyard last wednesday unfortunately.

 

I do not believe I do. I remember thinking about taking it, and then thinking that no one would ever want that, so I think I left it in the car. I will let you know if I find it in my pile-o-parts.

 

This is a PSA and free bump......

Buy Neal's parts so he can fund his turbo build and won't get spanked by Mustangs, 350Z's and Corvette's.

 

Looking for A/C Blower Motor (under dash)
Also, how much for the MAF?