00vi Kit $250 shipped
#1
00vi Kit $250 shipped
I just got a hold of a MEVI, so I've decided to sell this 00vi setup I have had just collecting dust. It's a little rough on the exterior but can be cleaned up fairly easily (original owner was worried about any vacuum leaks due to being boosted, so there's a lot of sealant and JB weld on some areas), and some of the nipples have been replaced with new brass fittings. I was just going to paint it crinkle black, but never got around to it.
It includes:
- Upper Manifold (EGR blocked off)
- IACV Adapter plate
- Lower intake manifold (have a spare 4th gen lower as well that I can include if you wish)
- Fuel rail and injectors
- RPM switch (Summit I believe)
- Throttlebody - Sealed (cleaned it to almost new condition since it was diiiiiirty when I bought it - and coolant bypass tube cause you know you always wanted to!)
- '00 rear valve cover and gasket
- '00 rear coils
- '00 injector clips
- All the mounting hardware
The bad:
This setup was originally used by a turbo maxima, so the fuel pressure regulator is hollowed out; an eBay universal one will do the trick. You will also need a new set of the injector O-rings as the ones on the injectors are a bit beat up (some tearing).
So for about $60 this will be ready to rock and roll.
Pictures: Note, there might be a few hardware items still somewhat scattered in my garage not pictured, quite a few parts down there, I just grabbed all the big bits that I had in a box...
It includes:
- Upper Manifold (EGR blocked off)
- IACV Adapter plate
- Lower intake manifold (have a spare 4th gen lower as well that I can include if you wish)
- Fuel rail and injectors
- RPM switch (Summit I believe)
- Throttlebody - Sealed (cleaned it to almost new condition since it was diiiiiirty when I bought it - and coolant bypass tube cause you know you always wanted to!)
- '00 rear valve cover and gasket
- '00 rear coils
- '00 injector clips
- All the mounting hardware
The bad:
This setup was originally used by a turbo maxima, so the fuel pressure regulator is hollowed out; an eBay universal one will do the trick. You will also need a new set of the injector O-rings as the ones on the injectors are a bit beat up (some tearing).
So for about $60 this will be ready to rock and roll.
Pictures: Note, there might be a few hardware items still somewhat scattered in my garage not pictured, quite a few parts down there, I just grabbed all the big bits that I had in a box...
Last edited by Mad-MAX_SE; 12-21-2009 at 04:56 PM.
Thread
Thread Starter
Forum
Replies
Last Post
maxprivate
4th Generation Classifieds (1995-1999)
14
11-29-2017 08:52 AM
Finkle
4th Generation Maxima (1995-1999)
13
09-27-2015 09:53 PM
Maximeltman
4th Generation Classifieds (1995-1999)
0
08-31-2015 01:01 PM