Full setup. 00vi egr guide tube, 00vi upper, 00vi tb, 00vi iacv, 00vi lower, 00vi rear valve cover, 3 00vi rear coils, 3 00vi front coils, 00vi injectors with rail and clips. All nipples on the upper are still here and good, comes with a bunch of needed bolts. $250

 

gaskets?

 

No gaskets

 

bump

 

shipped to 33157?

 

280 shipped

 

260 shipped conus. bump.

 

What else would I need other than this setup?

Shipped to 78612?

Or pick up?

 

Buy my whole car. I have the whole setup with the Engine and everything, as well as the 5spd transmission. lol

 

What you will need will depend on the 00vi setup you go with, there are a ton of ways to configure it. But you will definitely need gaskets. Its $260 shipped in the CONUS or $200 picked up, saves me the hassle of shipping it.

 

bump

 

It appears that this is everything needed if one does the type #1 swap (from the 00VI manual). Is that correct?

The manual says the fuel rail needs to be adapted to fit the 4th Gen fuel lines - was this already done or was this not pulled from a converted 4th Gen?

 

Yes, I think it is. Havent been able to see the old 00vi manual lately, the site it was on stoped hosting it. Not sure about adapting the fuel rails. If you run the #1 setup it should be the 5th gen everything, so you would be using the 5th gen fuel rail afaik. The fuel rail is included too.

I just looked at it again and the old gasket that goes between the uim and the lim is still there. All the fuel injector orings are there too.

 

If you have an IACV adapter plate, willing to sell it on its own?

 

still for sale?

 

still for sale?