I have all the wiring harness and full swap parts for sale. I didnt have the time to put into the project and parted out the car. Everything is complete and you can read the full thread here.

This includes the following to complete a full 3.5 swap that utilizes the fully functioning BIAS and VTC. With this installed the swap would also allow a very ambitious person to also go one step further and install an 09 engine in their 4th gen and do what SurraTT did to his 5th gen but in a 4th gen.

Someone on this forum could be the first to do a 4.7 swap...

Essentially what a Full Swap is does is makes your car think as far as the engine is concerned that the engine is a 2002-2003 5.5 gen maxima. All of the running gear is from an 03 maxima and the engine runs off an 03 ECU.

What is included:
2003 Gauge Cluster
2003 Drive by wire Pedal
2003 ECU
2003 NATS and key assembly (the key came from the same car as teh ECU so it will not have to be reprogrammed)
2003 Engine Harness (harness under the hood that is completely swapped out with the stock harness)
2003 custom patch harness - this is where all the hours and hours of my work has been. This harness is a stock 2003 dash harness that has been trimmed down to a plug and play harness that essentially converts the 2003 engine harness so that it plugs directly into your stock 4th gen harness. What is left to be completed is the power portion of the harness. All of the wires for the various components have been worked out.

To make this all work you will have to solder in one connection with about 20 wires to the various places (very simple....just tedious and takes some tenacity on your part to find the correct wires and understand what goes where). I can walk you through what I know as well.

http://forums.maxima.org/all-motor/6...p-harness.html

[*]$350 - Complete wiring harness and all associated parts for full swap. This includes: dash gauges, pedal, ignition switch, ECU, extra ECU brackets, Engine harness, and NEARLY completed conversion harness (see the attached thread). The only piece I have not completed of the conversion harness is the power portion of the harness…everything else is complete and I just don’t have the time to finish the project. Full Swap harness

 

Hey I'll take this if its not already gone!!

 

Got your PM and number. Just left you a VM.

 

Sold...lock it up