APEXI WS on 97+
#1
APEXI WS on 97+
I was browsing the warpspeed website and came accross this which sells for $20:
This replaces the "S" pipe section behind the converter, I know people have drilled a hole to add the O2 sensor to the WS, but what if you use this between the converter and the exhaust and plug the O2 sensor there. It will also allow the exhaust to line up better with the 97+ rear bumper since it stick out a little further
Any opinions on this? Will all the hanger points match up? Any other problem that this might cause?
PS: this is what the stock looks like
This replaces the "S" pipe section behind the converter, I know people have drilled a hole to add the O2 sensor to the WS, but what if you use this between the converter and the exhaust and plug the O2 sensor there. It will also allow the exhaust to line up better with the 97+ rear bumper since it stick out a little further
Any opinions on this? Will all the hanger points match up? Any other problem that this might cause?
PS: this is what the stock looks like
Thread
Thread Starter
Forum
Replies
Last Post
Maxima_Joe
4th Generation Classifieds (1995-1999)
16
11-25-2015 08:19 AM