Post Ypipe CEL
04-04-2004, 07:32 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2004
Posts: 17
Post Ypipe CEL
I made a previous post about this is problem, but the thread is long gone.
After installing a budget ypipe my CEL came on. the codes pulled are
0307
0308
0901
1001
From what I gather. these codes all refer to the oygen sensors. I have reset my ECU using the screw and by disconnecting the battery. After about 2 starts or a few minutes of driving, the light comes back on.
I had no problems with my 02 senors before the install. After the install, I realized the exhuast shop had not plugged in one of the senors to its harness, and I drove 200 miles before realizing this and fixing it. Since then I have driven several hundred more miles, and the CEL has not turned off. What went wrong and how can I get ride of the codes?
After installing a budget ypipe my CEL came on. the codes pulled are
0307
0308
0901
1001
From what I gather. these codes all refer to the oygen sensors. I have reset my ECU using the screw and by disconnecting the battery. After about 2 starts or a few minutes of driving, the light comes back on.
I had no problems with my 02 senors before the install. After the install, I realized the exhuast shop had not plugged in one of the senors to its harness, and I drove 200 miles before realizing this and fixing it. Since then I have driven several hundred more miles, and the CEL has not turned off. What went wrong and how can I get ride of the codes?
good luck getting everything straightened out
Thread
Thread Starter
Forum
Replies
Last Post
jmlee44
4th Generation Maxima (1995-1999)
8
10-02-2022 02:13 PM
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM