Ok so I finally have my GReddy SP2 and my WarpSpeed Y pipe on my Max I do everything turn the car on and I knew the CEL would be on because I took the O2 sensors out so I ran the codes bank 1 and bank 2 sensors and the one I didnt know about was the bad knock sensor. The KS wouldnt trip the computer right? If so did anyone else have this problem or should I just reset again? I'm sure the guy before me never changed the KS because I have every single receipt from when it was bought but I don't remember seeing a KS.

 

If CEL is in that is good. Means ECU detected new setup and will make proper adjustments...







just kidding...

Try resetting it again. I see you are '95, maybe it is time to replace knock sensor. Do the resistance check.

 

Well it was throwin the KS code but it wasn't throwin it before the Ypipe and I didn't think the KS would turn on the CEL