Installing bumper lights
#5
Originally Posted by 98MaXeDouT
......
How To:
It's a very quick change, and you'll need flat-tip and phillips screwdrivers. The light closest to the rear of the car can be popped out w/ the flat-tip by wedging it between both lights - be VERY gentle! With some prodding and pressure, it will come out. Afterwards, you'll see that the longer of the two lights is tacked in the bumper by a phillips screw. Unscrew, pop out the light and you're set.
Also, it's a good idea to inspect the clear lenses where they mate up to the light housings. Often, the quality is quite poor on these aftermarket clears, and will leak like a sieve. I'd recommend a nice skin of clear silicone between the lense & housing, and you shouldn't incur water problems thereafter.
Hope this helps.
#7
stick a flat head screw driver in between the two pieces: move the handle fo the screw driver towards the LEFT wen working with the driver side lights adn move it to the right w/the passenger side. basically u gotta POP the side lights out and the inner one is screwed in, which u'll be able to see after you pop out the side/outter lights. not hard at all
#8
Originally Posted by gtr_rider
holy jesus, theres a faq dude seriously..
Yeah, if the link wasn't broken.
#9
Thread
Thread Starter
Forum
Replies
Last Post
vingodine
5th Generation Classifieds (2000-2003)
45
05-21-2016 12:46 PM
kirkhilles
5th Generation Maxima (2000-2003)
2
08-08-2015 10:53 AM