Finally I can post a new message! Anyway, I have been having some problems with the 2 cables that are attached to the positive battery terminal. I had replaced the entire positive cable because it was all corroded. The first problem was the bose radio display would display fine, and then fade in and out.. I had first thought it was the display going bad, until I played around with those 2 cables and it would be fine. Then yesterday out of no where for the first time in 2 years my max started actin up. When I would start off from a start, unless I gunned it, the car would feel like it was going to stall out. It would start going fine, then bog down a bit, then pick up again. I know its not my clutch cause I just replaced that not too long ago. You guys think it could have anything to do with those 2 wires possible shortin out or something?

Thanks for any suggestions in advanced.



Missin my SR20 240sx....

 

BUMP for response. Talking about the two little wires that go along with the positive cable and go onto the terminal with it. Let me know if they have any control of the car's running/idle, don't know what else could have caused the car to act up like that.