Need to know what to torque the flywheel bolts down to (stock flywheel). Can't find it in my Haynes or my FSM.

 

69 ft-lbs. i think it's under driveplate on page 2B-2 in the haynes.

 

Yep just found it myself... its in the engine mechanical section in the FSM instead of the clutch section... 61-69 it says thanks bro.

 

if only there is an impact wrench or air ratcher that has a digital read out of how much torque is being applied. Or set to to not exceed a certain amount of force.

or am I just a lazy dreamer?

 

Let me know when its done Neal, and I'll be up there.

 

what kinda project u got going on over there?

 

New motor and trans. Blew up the old motor and the trans bearings are taking a crap. Actually I ended up putting the old trans in because the morons at the salvage yard didn't ship out my VLSD axle that I ordered LAST TUESDAY. Called them friday to ask where the F it was and they were like "oh we forgot to ship it out" so I put the old trans in and I'm going to keep the VLSD out until I get it built up. Got the new motor and trans in, everything hooked up, think she's ready to fire up (knock on wood) except for the fact I need to go buy a 1/2" breaker bar to get the trans fill plug open and put some MT-90 in it. Then I hook up the battery and hope I don't blow myself up

 

Is this the turbo car or beater?

 

turbo car haha, I wouldn't sink this much effort into the beater