[To: DaveB ] Dashboard Questions?
#2
I'll tell you how I did it, with good results.
1. Wash the part with soap and water.
2. Sand lightly with 600 grit paper.
3. Wipe the dust off with a wet rag.
4. Prime with spray on white sandable primer.
5. Sand any rough spots until completely smooth, wipe down.
6. Spray at least 4 coats of Krylon "Metallic Silver" (sanding again between coats to remove rough spots)
7. Spray on at least 2 coats of glossy clear coating.
Enjoy.
You can see pics on my homepage...
1. Wash the part with soap and water.
2. Sand lightly with 600 grit paper.
3. Wipe the dust off with a wet rag.
4. Prime with spray on white sandable primer.
5. Sand any rough spots until completely smooth, wipe down.
6. Spray at least 4 coats of Krylon "Metallic Silver" (sanding again between coats to remove rough spots)
7. Spray on at least 2 coats of glossy clear coating.
Enjoy.
You can see pics on my homepage...
Thread
Thread Starter
Forum
Replies
Last Post
Unclejunebug
5th Generation Maxima (2000-2003)
10
04-02-2016 05:42 AM