Here's a pic of my stereo mounted with my Techtom MDM100. I removed the factory panel and used it as a template for the mounts and fitting. When I found the right plastic (closest I could find to the factory plastic), I cut the template from particle board, made sure of the fitment and cut the holes for the components. The cuts are extremely close (the PR-1 headunit folds down). I have room for one more component (to be named later) when ready to be installed.

http://home.swbell.net/dgcoop/widestereo.jpg

http://home.swbell.net/dgcoop/stereotechtom.jpg

damn...thats pretty clean....BTW this is the 1st time i saw the new paint job....it looks awesome....

What did you cut the plastic with? It looks so clean!

Sweet!!

very nice..

what? no Pikachu yellow repaint? i'm disappointed..

Suh-weet!
 

It's so good, I might have to bite your style a bit;) I have the double DIN head unit, and I can't find any replacements for a decent price. There's a Jensen for around $400, but I heard it sux. I might just get a single and an EQ, if I can dupe the sweet job you did...

Black....
 

You don't need to make a custom face if you want to do a DIN sized deck and DIN sized EQ. Everything screws in to the existing supports, Don, had to make the face cause his stuff is not DIN sized. I have a DIN deck and DIN EQ in my car, no mods required. If you notice the base models only have a DIN sized deck and an additional DIN sized compartment underneath, as well as the little flapped one. :-)