Here's a pic of my stereo mounted with my Techtom MDM100. I removed the factory panel and used it as a template for the mounts and fitting. When I found the right plastic (closest I could find to the factory plastic), I cut the template from particle board, made sure of the fitment and cut the holes for the components. The cuts are extremely close (the PR-1 headunit folds down). I have room for one more component (to be named later) when ready to be installed.

 

damn...thats pretty clean....BTW this is the 1st time i saw the new paint job....it looks awesome....

 

What did you cut the plastic with? It looks so clean!

 

Sweet!!

 

very nice..

what? no Pikachu yellow repaint? i'm disappointed..

 

It's so good, I might have to bite your style a bit I have the double DIN head unit, and I can't find any replacements for a decent price. There's a Jensen for around $400, but I heard it sux. I might just get a single and an EQ, if I can dupe the sweet job you did...

 

You don't need to make a custom face if you want to do a DIN sized deck and DIN sized EQ. Everything screws in to the existing supports, Don, had to make the face cause his stuff is not DIN sized. I have a DIN deck and DIN EQ in my car, no mods required. If you notice the base models only have a DIN sized deck and an additional DIN sized compartment underneath, as well as the little flapped one. :-)