during the flooding of the north east the other week, one of my fog hid ballasts got wet and took a ****.

so i had it replaced (under warranty), and proceeded to re install it. so everythings fine. mind you, when i first installed the hid fogs, i pulled to a wall 25 ft, and marked it 4" down from the middle of the fog lens, as required for correct use.

i didnt touch these screws ever since. (no reason to). i re mount the ballast. i put the fog back in, and whadda u know, they are shining almost to the floor.

so i first think thats weird. i did remove them, but the screw is untouched. so i re adjust the drivers side, and its ok. the passenger side however, doesnt move at all when im adjusting either way.

i did also notice a huge difference...negatively in the light output. its like horrible.

does anybody know a. why my screw wont adjust the reflector? and b. what happened to my light output?