i recently bought some obxV2 headers for a 02-03 and put them on my car last week. the instal wasnt to bad but just make sure u have patience and a grinder .

My exhaust set up is simple. Greddy sp2, 2.5 test pipe and obxV2 headers

enjoy









PS: im not s/c the whining noise u hear is my alternator. i have a new one but ive been to lazy to change it

Sounds good. Hows the sound inside the car?

quiet....doesnt bother me

Sounds good.

sounds good.

I'm sold on the OBX equal length... and yes it was ultimo ghey

Fresh.

nice...

Appreciate that. Aside from the test pipe, oh and the OBX's (coming very soon), I have the EXACT same setup.

Grinder you say? What'd you have to grind down? The xmember?

yup

Too bad the mic couldnt handle all the noise.

yea i know

sounds wicked nice, no rasp at all

Any chance you have pics of the grinded section of the xmember so I know what Im getting into?

Nope..not yet

^ Yet? Meaning you WILL have some? 4sho I could definitely use it for reference. Appreciate it bruh.

Should have some up tomorrow

cant wait to order my SP2 now, finally a good vid with someone revving up their car for an exhaust clip

Mines might be up for sale soon

Wierd... How am I the only person w/ clearance on the xmember with my headers?

Iono...u might be one of the lucky ones...

Guess so, I have just enough room to squeeze a nickel and maybe a dime between the header and xmember.

I jus saw your right up. I wanted to take my crossmember off but it was a little rusty. I'm sure that wouldve made things easier. But I still thin my crossmember wouldve needed to be cut because the headers wouldn't line up until I started cutting it

Your whats for sale soon? SP2 or OBX v2? If V2, I want em!!!!!!!

edit: oh youre the OP. Not likely youd be selling these after just installing.....or would you???

I was talking about my exhaust

Damn ....what are you replacing it with?

3" test pipe and 3" catback

sounds sooooooooooo good

did you take pics of where you had to mod your cross member? I already ground down some of my rear motor mount and then some of the cross member is down by the rear "loop", and I am thinking I still need to grind down some back by the flex section.

I actually was under the car yesterday and completly forgot.sorry fellas

When you get another chance, pics plz!

thats sounds great

I like your thinking, but what are you goin to do about cattman's 2.75" inlet? unless you're going full custom?

Custom mandrel bend

when yall ready to do another obx install

U can do it yourself. Stop being a skirt

id rather help boost the economy

It aint that hard in retrospect I can do it in one night after the first fiasco.