Good morning guys. I've gotten my hands on both an EMU with the version E board, as well as a custom PNP harness. I'm aware that there isn't any soldering required on the Ver. D board, but I was wondering if it's the same for Ver. E. I've heard of people having the melting ignition coil issue on some of the older version, but wasn't sure if it was the same for mine. Any help would be greatly appreciated!!

 

where would i even find an emanage and vq30 harness?

 

Emanage is universal and so is the patch harness but you could get a plug and play harness.

 

dandymax did a write up on this some time back. It may be on MY4DSC

The link below, it will take you to it.
vqpower.com/images/howto/euinstall/DandyMaxEUWriteup.pdf