24KP-I-M-P

i just finished installing it yesterday on me and my friends car. took 6 hours for both cars went through 3 cordless drills cause they batteries kept wearing down so we had to borrow 3 different drills.
to any one that has the kit did you install yours with those cheap *** plastic clamps that dont hold the weight.
i dont have a body kit on my car and the tubes are hanging sorta low up close you cant tell but as you walk away from the car the neon tube becomes more visable.

im thinking of going to home depot today to try and find some better clamps that will hold it tight agains the body of the car.

any suggestions would be much appreciated as im very tired after spending half my day under my car.
im really lazy right now and just want to duct tape it to the body for now.

bullseye

Sounds like you could use a better-quality drill bit, too. Buy the most expensive [cobalt] drill bit you can find at Home Depot. It will drill holes through the metal on your car like a hot knife through butter. And it'll probably only cost around $5 or so. It sure beats spending 1/2 your day under the car with three different drills... Good luck.